4 Prepare the turbine meter for use
4.1 Lifting conditions
WARNING
CRUSHING HAZARD
During turbine meter installation or removal, always place the unit on a stable platform
or surface that supports its assembled weight.
Failure to comply could allow the turbine meter to roll, resulting in death, serious injury
or equipment damage.
WARNING
LIFTING HAZARD
The lifting instructions are for installation and removal of the Daniel Liquid Turbine
Meter only and do not address lifting the turbine meter while it is attached or bolted to
piping.
Failure to comply with these instructions may result in death, serious injury, or
equipment damage.
CAUTION
FORKLIFT HAZARD
Do not insert the forks of a forklift into the bore when moving the turbine meter.
Inserting the forks may cause the meter to become unstable, resulting in serious injury
or equipment damage.
Table 4-1: Lifting and installation conditions
Conditions Description
Lighting and ventilation Install the turbine meter in a well lit and ventilated location, not
less than one meter (approximately three feet) from source of
ignition or source of heat which might damage the unit.
Work area clearances and
installation height restrictions
Refer to Minimum clearances for installation, operation and
maintenance.
Surface considerations Stable surface.
Soil/floor loadings and
product/piping support
Follow local procedures that meet the standards for soil/floor
loading and product/piping support.
User manual Prepare the turbine meter for use
P/N 3-9008-515 March 2019
User manual 57
To Next Page
Loading...
Need help?
General
