Emerson GO USB Logger User Manual

6
Note: Once battery is depleted, it cannot be recharged and should be properly discarded according
to local recycling guidelines. It is recommended that replacement batteries be the same make and
model. Should you replace
1
the battery with a different ER14250 battery model, please review the
manufacturer’s safety documentation and certications such as:
The GO USB Loggers come with pre-installed, non-rechargeable ER14250 ½ AA batteries. Ensure
battery compartment is securely in place prior to use.
• Material Safety Datasheet
• UN 38.3 report
• Other certications as applicable
Battery Installation
1
Screwdriver not included
To start recording, press and hold Start for
~
3 seconds and then release. A green LED will ash
and a REC symbol will appear on the LCD to indicate successful activation. The LED light will ash
intermittently to indicate active recording. In the event of an alert, the LED will ash a red color. The
unit can be congured to alert with sound. You may disable the sound by pressing and holding the
STOP button for
~
0.5 seconds. To stop recording, press and hold Stop for
~
3 seconds and release.
The REC symbol will disappear to indicate successful deactivation. The LED light will no longer blink
intermittently.
Operating Instructions
Note: To prevent accidental deactivation, the conguration software has an option to disable
the stop button. In the event the logger does not stop recording when pressing the stop button
for 3 seconds, it is likely this feature has been enabled. Reconnect the logger to a PC and use the
conguration software to stop the logger. See the Conguration Software section for more detail.

Emerson GO USB Logger Specifications

General

Brand	Emerson
Model	GO USB Logger
Category	Data Loggers
Language	English