Emerson QuickPanel+ IC755C S06RD Series User Manual

Quick Panel Operator User Manual Section 3
GFK-2847AA Jan 2023
Software 41
• Section 3.14.6, Establish SNMP Communication
3.14.1 Configure Trap Destinations
TRAP Destinations are configured through the QuickPanel
+
Setup Tool by
providing the IP Address of the SNMP Manager to which Traps should be
sent. The user can configure two different Trap Destinations (IP
Addresses).
Note: If you do not want to be notified of Traps, you do not need to configure Trap Destinations.
To configure Trap Destinations
NOTICE
If Trap Destination(s) is/are configured after enabling the SNMP Agent on the device, it is
highly recommended that you subsequently disable and then re-enable the SNMP Agent
service on the device.
1. From the Start menu, select System, open the QuickPanel
+
Setup Tool, and select the SNMP Agent tab.
2. Configure the Trap destination(s) of the SNMP Manager.
Figure 40: Specify IP Address(es) as Trap Destination(s)
3. Click OK to save the changes.
Close the QuickPanel
+
Setup Tool, then re-open the tool to view the
configured Trap Destination details from the SNMP Agent tab.

Emerson QuickPanel+ IC755C S06RD Series Specifications

General

Brand	Emerson
Model	QuickPanel+ IC755C S06RD Series
Category	Monitor
Language	English