Quick Start Guide
17
February 2019
6.0 Trim the transmitter (optional)
Devices are calibrated by the factory. Once installed, it is recommended to
perform a zero trim. A zero trim is a single-point adjustment to compensate for
mounting position. When performing a zero trim, ensure the vent tube is vented
to atmospheric pressure.
6.1 Zero trim using the Field Communicator
1. Connect the Field Communicator
(see “Connect wiring and power up” on page 13 for instructions).
2. At the main menu, input the 3, 4, 1, 3 Fast Key sequence.
3. Follow the commands to perform a zero trim.
00825-0100-4520_RevAC.fm Page 17 Thursday, February 7, 2019 10:16 AM
To Next Page
Loading...
Need help?
General
