IQ8AC/IQ8HC Installation and Operation Manual
8 © 2023 Enphase Energy Inc. All rights reserved. June 2023
USM-00005-2.0
• Do not expose the IQ Terminator cap or IQ Cable connections to
continuous tension (e.g., tension due to pulling or bending the cable
near the connection).
• Use only the compatible IQ connectors.
• Do not allow contamination or debris in the connectors.
• Use the IQ Terminator cap and cable connections only when all parts
are present and intact.
• Do not install or use in potentially explosive environments.
• Do not allow the IQ Terminator to come into contact with an open flame.
• Fit the IQ Terminator cap using only the prescribed tools and in the
prescribed manner.
• Use only the IQ Terminator to seal the conductor end of the IQ Cable; no
DC Cable safety
• Ensure proper routing of PV module DC cable using the clips to prevent
the leads from resting on the roof. Do not wrap excess DC cable around
the microinverter.
• Avoid direct exposure to sunlight.
• Avoid sharp edges on racking.
• Avoid cable contacting rough surfaces or moving parts within the
racking system.
• Avoid overly tight bending radii. The minimum bend radii for the DC
cable is 8 X cable outer diameter.
• Avoid overly tight-sized cable clips for routing.
To Next Page
Loading...
Need help?
General