66
Saving a User's Logo
You can record the image that is currently being projected as a user's logo.
PROCEDURE
A
Project the image you would like to use as the user’s
logo, and then display the configuration menu.
B
Select “Extended” from the configuration menu, and
then select “User’s Logo.”
For details on this operation, refer to
“Using the Configuration
Menu.” sp.34
Check which buttons on the remote control or the control panel
you can use, and the operations they perform, in the guide at the
bottom of the screen.
When a user's logo is recorded, the previous user’s logo
will be erased.
Remote control
Control panel
•If the “User’s Logo Protect” function of “Password
Protect” is set to “ON,” a message is displayed and the
user's logo cannot be recorded. To record a user's logo,
set “User’s Logo Protect” to “OFF” first. sp.30
•If keystone correction, Zoom adjustment, or E-Zoom
and so on, have been carried out, the function currently
being performed is cancelled when the “User’s Logo”
menu is selected.
To Next Page
Loading...
Need help?
General
