To Next Page

To Previous Page

Confidential

Adjustment Required Adjustments 70

M200 / M205 / M100 / M105 Series

Revision A

1. Move the CR Unit to the center of the printer.

2. Place the thickness gauges (1.6 mm) on the position A shown in Figure 3-1.

Figure 3-1. Position of the Thickness Gauge

3. Pull the CR Timing Belt to move the CR Unit to both ends and confirm the CR Unit does not touch the

thickness gauges.

4. Move the CR Unit to the center, and place the thickness gauges (1.6 mm) on the position B shown in Figure

3-1.

5. Pull the CR Timing Belt to move the CR Unit to both ends and confirm the CR Unit does not touch the

thickness gauges.

6. Move the CR Unit to the center, and place the thickness gauges (2.0 mm) on the position A shown in Figure

3-1.

7. Pull the CR Timing Belt to move the CR Unit to both ends and confirm the CR Unit touches the thickness

gauges.

8. Move the CR Unit to the center, and place the thickness gauges (2.0 mm) on the position B shown in Figure

3-1.

9. Pull the CR Timing Belt to move the CR Unit to both ends and confirm the CR Unit touches the thickness

gauges.

Note "*1": If the CR Unit comes in contact with the thickness gauges, the PG is smaller than the standard value, therefore, check if the

unit is correctly reassembled. If not, reassemble the unit and perform PG check again. (If the unit is correctly reassembled,

replace the unit with a new/refurbished one.)

"*2": If the CR Unit does not come in contact with the thickness gauges, the PG is greater than the standard value, therefore, check

if the unit is correctly reassembled. If not, reassemble the unit and perform PG check again. (If the unit is correctly

reassembled, replace the unit with a new/refurbished one.)

80-digit side

0-digit side

Thickness gauges

Epson M100 Service Manual

Other manuals for Epson M100