Deformed
Attaching the Roll Core
Preparing
Get a take-up roll core that is the same width as the
media.
Get a commercially available adhesive tape.
Loading
A
After confirming that the media is loaded
correctly, keep the d button pressed until the
edge of the media reaches the roll core holder.
c
Important:
Always press the d button to feed the media.
If the media is pulled by hand, the media
may twist during take-up.
B
Loosen the roll core holder fixing screws on
both sides and adjust the roll core holders so
that the distance between the two is wider than
the media.
If the roll supports are not positioned evenly,
move them so that they are even.
c
Important:
If the left-side roll core handle's shaft is not
visible, rotate the handle as shown in the
illustration until it stops. The roll core
cannot be properly loaded if the handle's
shaft is not visible.
SC-F9300 Series User's Guide
Basic Operations
34
To Next Page
Loading...
Need help?
General