5-10 Application Development Information Rev. D
5.5 Printing for journal used
This printer can print on carbon paper (original + 1 copy.) This is available to use for journal.
When you use this printer “Type A” model, you can take up the copied paper with Auto take-up
unit. If you use this printer “Type B“ model, you can cut each a receipt and the copy at same
time.
A special control isn’t required to use carbon paper; you can treat it as same as normal paper.
However, when you use the Type A model with Auto take-up unit, you have to install carbon
paper with Auto take-up unit. Please refer “Installing the Roll Paper for Type A” (page 3-9).
5.6 What is “Right side up printing“ ?
“Right side up printing“ is a printing mode used for printers installed on a wall.
However, the right side up printing mode has some limitations, some of which are listed below.
If you want to use the right side up mode, please contact us and get the manual “Guide for
TM-U220 right side up printing.“
• The right side up printing mode isn’t supported any driver (OPOS and Advanced
printer driver [APD]) or utility software. You have to control the printer directly by
ESC/POS commands.
• When you install the right side up mode printer into your system (application program),
you may need to modify the program.
• The right side up printing mode requires DIP switch 1-2 (receive buffer: 4KB) to be
turned off.
• The right side up printing mode isn’t provided for the Type A model and multilingual
model.
ABCDEFG...
1234567890...
ABCDEFG...
1234567890...
Normal printing mode
Right side up printing mode
To Next Page
Need help?
General
