8
English
Radio
Note: Press [MO/ST] on the remote to select between mono or stereo.
A ”crooked arrow” symbol will appear to indicate stereo playback. Stereo playback
can only be effectively used in good radio reception conditions.
1. Turn on the speaker dock as described in step 2 in the iPod/iPhone playback
section above.
2. Press [FM] on the remote or press [INPUT] on the speaker dock until ”FM” and
the current radio frequency shows in the display.
3. Set or fine tune a desired frequency by pressing [◄◄] or [►►] until a strong
undistorted signal is received on the desired frequency. Frequency is adjusted in
0.05 MHz increments.
4. To automatically search for the next station hold down [◄◄] or [►►] for
a few seconds.
Automatic station search and save
60 station presets are available.
1. In radio mode, press [SEARCH] on the remote to start automatic station search
and save.
2. Press [SEARCH] again to stop searching.
Manual save
To save e.g. 99.30 MHz on preset 18:
1. In radio mode, press [10+] once and then [8] once on the remote to select the preset.
2. Then press [F] and enter [9], [9], [3], [0].
3. Finally press [SAVE] to save.
Changing stations
In radio mode:
1. To listen to preset 3, press [3] on the remote.
2. To listen to preset 15: Press [10+] once and then [5] once on the remote.
3. Press [l◄◄] or [►►l] to go to the next station.
Care and maintenance
• Unplug the mains adaptor from the wall socket and remove the batteries from
the speaker dock if the product is not to be used for a long time.
• Clean the product using a lightly moistened cloth. Only use mild cleaning agents,
never solvents or corrosive chemicals.
To Next Page
Loading...
Need help?
General
