FAR LV12C47MI17IX - Starting and Modifying Programs

ENGLISHENGLISH
GB-7GB-6
Check the
regeneration
saltlevel
(On models with water softener
system only.)
Electric indicator on control panel
(if provided).
If there is no salt warning light
in the control panel (for some
models), you can
estimate when to
ll the salt into
the softener by the
number of cycles
the dishwasher has run.
Load the
baskets
Scrape o any large amount of
leftover food. Soften remnants of
burnt food in pans, then load the
baskets. Refer to the dishwasher
loading instructions.
Select a
program
Close the door, press the program
button until the selected program
lights up. (See the section entitled
Operation instruction )
Running
the
dishwasher
Turn on the water tap and press
the Start/Pause button. e
machine will start working after
about 10 seconds.
Changing
the program
1. A running cycle can only
be modied if it has been
running for a short time.
Otherwise the detergent may
have already been released and
the water already drained. If
this is the case, the detergent
dispenser must be relled.
2. Press the Start/Pause button,
then press the program button
more than 3 seconds to cancel
the running program.
3. Select a new program.
4. Restart the dishwasher.