GB-43GB-42
NOTE:
When following this procedure from step1 to
step 2, the lter system will be removed; when
following it from Step 2 to Step 1, the lter
system will be installed.
Remarks:
– Inspect the lters for blocking after every
time the dishwasher has been used.
– By unscrewing the coarse lter, you can
remove the lter system. Remove any food
remnants and clean the lters under running
water.
NOTE: e entire lter assembly should
be cleaned once a week.
Cleaning the Filter
To clean the coarse lter and the ne lter, use
a cleaning brush. Reassemble the lter parts
as shown in the gures on the last page and
reinsert the entire assembly in the dishwasher,
positioning it in its seat and pressing downwards.
WARNING!
When cleaning the lters, don’t knock on
them. Otherwise, the lters could be contorted
and the performance of the dishwasher could be
decreased.
Caring for the Dishwasher
e control panel can be cleaned by using a
lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish
wax.
Never use sharp objects, scouring pads or harsh
cleaners on any part of the dishwasher.
Cleaning the Door
To clean the edge around the
door, you should use only a
soft warm, damp cloth.
To avoid penetration of
water into the door lock and
electrical components, do not
use a spray cleaner of any kind.
To Next Page
Loading...
Need help?
General
