EasyManuals Logo
Home>FENDT>Engine>MAN D 0836 LE

FENDT MAN D 0836 LE User Manual

FENDT MAN D 0836 LE
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
Fav 900
Engine / Cylinder head
Removing and refitting valves
G
Repair
Fav 900 chassis number 23/3001 and up
19.02.2001
2010 000008
G
a
2/3
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting valves
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Turn cylinder head over.
Place valve fitting lever.
Fit washer, valve spring and upper spring plate.
PMTAB_Picture
Compress spring with fitting lever and insert
collets.
Note:
Make sure collets fit properly: they can cause
severe damage by springing out.
PMTAB_Picture
Measuring valve recess
Position gauge holder with dial gauge at the
cylinder head.
Press tip of gauge onto cylinder head.
Set dial gauge at "0".
Swing gauge towards valve head and read
recess.
PMTAB_Picture
If after skimming the cylinder head faces, valve
recess is inadequte or valve projection is
excessive, the valve seat insert must be
re-ground.
1 Valve recess
Note:
- When skimming the cylinder head sealing
face, the max. dimension must not exceed 1
mm (0.039“).
- After skimming, observe injection nozzle
projection. Replace standard - copper sealing
ring with a thicker one.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FENDT MAN D 0836 LE and is the answer not in the manual?

FENDT MAN D 0836 LE Specifications

General IconGeneral
BrandFENDT
ModelMAN D 0836 LE
CategoryEngine
LanguageEnglish