Fav 900
Engine / Short block
Removing and refitting the starter engine
G
Repair
Fav 900 chassis number 23/3001and up
26.02.2001
2210 000014
G
a
1/1
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting the starter engine
PM-Picturemodule
PM-Picturemodule
Text-module
Check flywheel ring gear for wear and damage by actuating the crankshaft by hand.
Check in particular the points which final engine oscillations occur ; i.e. when turned off, there are
points where the engine comes to rest.
The starter engine pinion engages in these positions during start up.
On 6-cylinder engines these points are staggered by 180° ; i.e. threre are 3 points.
To replace the starter ring gear see chapter 2000 Reg G.
PM-Picturemodule
PMTAB_Picture
Removing the starter
Disconnect earth terminal from battery.
Remove cables terminal 30 (thick cable) and
terminal 50 from the starter.
PMTAB_Picture
Unscrew the screws and a nut from the starter
motor flange and remove the starter motor.
Clean exterior of starter engine and check for
damage.
PMTAB_Picture
Refitting the starter
Refit the starter in reverse order of removing,
making sure cables are connected correctly.
Observe torque values.
Reconnect battery.
On completion, check starter for correct
functionning.
To Next Page
Loading...
General