Fav 900
Engine / Short block
Power - belts
G
Repair
Fav 900 chassis number 23/3001and up
26.02.2001
2210 000016
G
a
3/3
Capitel Docu-No.
Index
Date Version
Page
Power - belts
PM-Picturemodule
Text-module
Determining the span force
Bullet-List
● Read tension force at the point of intersection of the upper side of the indicator arm (1) and the scale.
● Before reading the values make sure that the indicator arm remains in its position.
If the value does not agree with the specified setting, the Powerbelt tension must be reajusted.
PM-Picturemodule
PMTAB_Picture
● Position tension gauge (2) in the center
between the generator pulleys and the
crankshaft.
● Slowly push pressure pad (3) down until the
spring snaps out audibly and the indicator arm
moves upwards.
Continued pressing after the spring has snapped
out will result in an incorrect reading!
Span forces measured on the kg-scale of instrument
Belt width Poly V 790 K 4
Newly fitted
When fitting 60
After 10 minutes running 45-50
Minimal span force 30
Re adjust tension if minimum
tension is reached.
40
PMTAB_Picture
Tensioning / replacing powerbelt
● Release clamping bolts(1).
● Loosen counternut (3).
● Adjust checking nut (2) for correct powerbelt
tension.
● Retighten counternut and clamping bolts.
When replacing powerbelts, slacken checking nut
(3) and swing alternator inwards.
To Next Page
Loading...
General