Fav 900
Engine / Short block
Removing and refitting flywheel
G
Repair
Fav 900 chassis number 23/3001 and up
15.02.2001
2210 000004
G
a
1/2
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting flywheel
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Remove flywheel
Loosen screws, holding starter ring gear in place
with a large screwdriver, if necessary.
Unscrew and remove two screws on opposite
side, replace with two guide mandrels (special
tool).
Unscrew all screws and remove clutch flange.
Using two M10, ease off the flywheel.
Remove clutch flange and disc.
Danger:
The flywheel is very heavy.
Use suitable hoisting gear.
PMTAB_Picture
Clean and check flywheel.
PMTAB_Picture
Refitting flywheel.
Position flywheel on two guide mandrels,
observing the correct aligment between centering
pin (arrowed) and flywheel bore hole: Refit disc
and clutch flange. Push on flywheel to end
position.
Apply a small amount of oil to the screws.
Insert and tighten to specified torque, alternating
sides.
To Next Page
Loading...
General