Fav 900
Engine / Short block
Removing and refitting flywheel
G
Repair
Fav 900 chassis number 23/3001 and up
15.02.2001
2210 000004
G
a
2/2
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting flywheel
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Replacing the starter ring gear
Remove fly wheel.
Drill starter ring gear and force open with a chisel.
Warning:
Do not damage the flywheel.
PMTAB_Picture
Note:
Since the maximal permissible axial run-out of
the starter ring gear must not be exceeded, it is
advisable to determine flywheel deviation at
ring gear contact face, before ring gear is
shrunk on. If this is in excess of the specified
value, the flywheel must be replaced.
Clamp flywheel to the hub.
Fit dial gauge to contact face of starter ring gear.
Rotate flywheel severals turns by hand and
observe gauge reading.
PMTAB_Picture
Heat new starter ring gear to approx. 220° to
240°C (428° - 464°F) and press on as far as
possible.
Warning:
Watch the position of chamer
(arrowed).
Check maximal deviation.
To Next Page
Loading...
General