Fav 900
Engine / Short block
Removing and refitting flywheel housing.
G
Repair
Fav 900 chassis number 23/3001 and up
15.2.2001
2210 000005
G
a
2/2
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting flywheel housing.
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Remove starter.
Remove flywheel.
Unscrew and remove the fixing bolts.
Note:
For easy assembly use two fairly long guide
pins.
Remove flywheel housing.
Caution:
The flywheel is very heavy.
Use suitable hoisting gear.
Remove gasket residues from flywheel housing
and crankcase.
PMTAB_Picture
Note:
If the replacement guide pins are fitted, their
projection must not exceed 30 mm: if this is
exceeded, they will be in contact to flywheel
throught the housing.
PMTAB_Picture
Refitting the flywheel housing.
Coat flywheel sealing face with sealing compound
"Terostat 63" and position on crankcase.
Insert screws (including those to the oil pan) and
tighten to specified torque.
Refit flywheel.
Refit starter.
To Next Page
Loading...
General