Pag. 12
Technical
* Bear these points in mind before deciding on what material you are going to need for the installation:
Choose the panel or group of panels neccessary depending on the number of dwellings, space available for the
installation etc.
Do not forget to keep a window free for the telecamera if it is a video door phone installation. The telecamera is not
included, so remember to order it apart (ref. 8028 in CityMax monitor installations).
The panels are supplied without mounting boxes, so do not forget to order them separately.
Where there is a combination of panels you will have to aquire seperaters for a perfect union between the mounting
boxes. A set of Joining Bolts Ref. 8829 will be neccessary for each additional panel.
The monitors have to be mounted on Installation Connectors which have to be bought apart.
1.7m
PRACTICAL ADVICE ON THE INSTALLATION
* Before installing the mounting box make whatever holes
are neccessary to introduce the wires.
The mounting boxes have various holes indicated for
introducing wires. Pierce those neccessary by giving them a
sharp tap with a hammer.
Bear in mind that the panels always have to be mounted in
vertical, so position the boxes according to the arrow engrave in
the base.
* Install the corresponding mounting box at a height of
1m 70cm from the top of the box to the ground and flush
with the wall.
Make sure that each box is left completely vertical, otherwise
the panel will end up twisted.
Bear in mind, especially in new constructions, that the height of
the floor may change, for example if the pavement or curb has
not been laid.
* In combinations of panels, assemble the boxes with the
seperaters before installing them.
Remember that you will have to pass wires from one box to the
other, so the neccessary holes will have to be pierced before
assembling them.
To Next Page
Loading...
Need help?
General
