1. Depress the deck lift foot pedal (B) until it locks into the 5”
(12,7 cm) position.
2. Place the cutting height adjustment pin in the desired cutting
height.
3. Depress the deck lift foot pedal then push the lock lever (C)
towards the right to release the lock.
4. Release the deck lift foot pedal until it comes to rest against
the cutting height adjustment pin.
Foot Pedal Adjustment
The deck lift foot pedal can be adjusted to accommodate the
operator’s height for optimal comfort.
To adjust pedal position:
1. Remove the foot pedal (A, Figure 39) from the pedal mount
tab (B).
39
2. Remove the pedal mount hardware (C) and rotate the tab
180 degrees.
3. Reinstall the pedal mount hardware and tighten securely.
4. Reinstall the foot pedal on the pedal mount tab in the proper
orientation as shown in Figure 39.
Floor Pan Removal & Installation
This unit is equipped with a removable floor pan which can be
removed to provide better access to the mower deck.
1. Loosen and remove the retaining hardware (A, Figure 40)
that secures the floor pan to the frame of the unit.
40
2. Tilt the back end of the floor pan up and then remove it from
the unit.
3. To re-install the floor pan: Reverse the removal procedure.
Neutral Adjustment
The neutral system for this mower consists of two neutral linkage
rods and a pivot that connects the ground speed control lever
to the transmission. The lower rod that connects the
transmission to the pivot is factory preset and should not be
changed for neutral adjustment purposes. The adjustment is
achieved by changing the length of the upper rod (A, Figure 41)
that connects the ground speed control lever to the pivot.
41
Determining if Adjustment is Necessary: If the tractor
"creeps" while the ground speed control levers are locked in
the NEUTRAL, then it may be necessary to adjust the linkage
rods.
NOTE: Perform this adjustment on a hard, level surface such
as a concrete floor.
29
To Next Page
Loading...
Need help?
General
