–25–
TESTING THE SYSTEM (Continued)
7. After all protection points have been checked and restored, there should be no zone
identification numbers displayed. If a problem is experienced with any
protection point (no confirming sounds, no display), CALL FOR
SERVICE IMMEDIATELY.
8. Turn off the Test mode by entering the security code and pressing the OFF key.
PAGING FEATURE
If the paging feature has been programmed for your system, your pager will respond to certain conditions as they occur
in your system by displaying a 10-digit code that will indicate the type of condition that has occurred. The 10-digit code
will use the following format: SSSS–EEE–NNN
SSSS will be your particular 4-digit subscriber No. (this same number will always appear at the beginning of the display
on your pager).
EEE will be a 3-digit number that describes the event that has occurred in your system (see explanation below).
NNN will be a 3-digit User or zone number, depending on the type of event that has occurred.
The 3-digit Event Codes (EEE) that can be displayed are:
911 = Alarm (NNN that follows this code will be the zone number that has caused the alarm)
001 = Open, System disarmed (NNN that follows this code will be the User number)
002 = Close, System armed (NNN that follows this code will be the User number)
811 = Trouble (NNN that follows this code will be the zone number that has caused the trouble)
Example 1.
Pager displays: 1234–911–004
This indicates that your system (Subscriber No. 1234) is reporting an Alarm (911), due to zone 4 (004) being faulted.
Example 2.
Pager displays: 1234–001–005
This indicates that your system (Subscriber No. 1234) is reporting an open/disarming (001) by User 5 (005).
To Next Page
Loading...
Need help?
General
