Introduction
Thank you!
For selecting a Firstech remote start security system as your product of choice. The following manual is a
complete Master guide to the CM900 universal Control Module and is intended for experienced and
authorized Firstech technicians only. If you need any further technical support, please call us at 888-820-
3690 dial 9 then ext. 203 or visit our website at www.firstechdata.com
Caution: The Manufacturer’s warranty will be void if this product is installed by anyone other
than an authorized Firstech dealer. Firstech provides installation support services to authorized
dealers only.
This manual may change frequently. Please check www.firstechdata.com for updates.
Kit Contents
All Firstech CM900 bundles include the following:
• CM900S or CM900AS main control module
• Wiring diagram sheet
• High Current ignition harness with one external relay (CM900AS only)
• Additional I/O Wiring harnesses
• Hood pin
• Mountable bright blue LED (CM900AS only)
• FT-SHOCK dual stage impact sensor (CM900AS only)
• RF Kits with remote(s), Antenna, and Antenna Cable
The following sensors are available but not included with every system:
• Drone
• Temperature sensor (FT-TEMP SENSOR)
• DAS II (2 stage impact, Tilt, Glass break all in one sensor)
The remote(s) and antenna are modular and are not specific to the control modules. You can pair almost any
Firstech remote(s) and antenna receiver to the CM900 control module.
Any questions on contents please contact your distributor or us directly at 1.888.820.3690, Monday
through Friday, 7A to 5PM Pacific Time.
To Next Page
Loading...
Need help?
General
