Firstech CM900AS User Manual

Alarmand StarterSystem
ww w .firstechdata.com
CM900 Master Guide
Copyright 2016 Firstech,
LLC.
Page 48
STEP 2: Scroll through menu waiting for 1 parking light flash and/or siren chirp per line.
STEP 3: Once finished scrolling through menu, wait for the parking lights and/or siren chirp to confirm the
option number. i.e. option 2-04 will flash and/or chirp 4 times. Select your option using the Lock, Unlock,
Trunk, or Start buttons.
Resetting to Factory Defaults: To reset the options in a menu, enter the menu using your remote. To reset
options with a 2 Way remote, tap the Trunk button 3 three times. To reset options with a 1 Way remote, tap
the Key/Start button 3 times. Wait for parking lights to flash and/or siren chirp between each tap. After the
third tap, the menu will reset back to default. This must be done for each option menu that must be reset.
Troubleshooting
Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those two flashes the parking lights will flash again corresponding to the error table below:
Number of
Parking Light
Flashes
Remote Start Error
1
Motor running or must program tach before 1st remote
start
2
Key in ignition on position
3
Door open (manual transmission only)
5
Foot brake on
6
Hood open
7
Reservation off (manual transmission only)
8
Tach or tachless sensing failure
9
DAS sensor shutdown
10
System is in Valet Mode
2 Way remotes will display the error number “Start Err##” on the LCD.

Firstech CM900AS Specifications

General

Brand	Firstech
Model	CM900AS
Category	Remote Starter
Language	English