10
!4 TROUBLESHOOTING
z
Excessive water remaining above the filter plate, after the rinse cycle (This can be displayed as an A20 fault)
Check for a kinked drain hose, blocked waste connection, highloop not properly installed, drain hose not routed correctly or spray arms not in place.
z
No water supply (This is displayed as an A10 fault)
Check water is connected and turned on.
z
The dishwasher is beeping continuously
There is a fault. See section ‘How to attend to a fault’ in the User guide for further information and instructions.
z
Water around water supply and drainage connections
Check connections, existing plumbing and hoses for leaks. Check rubber washer and hose clamp are correctly fitted.
z
If product is tipping
The product is not secure under the benchtop. Ensure the product is level and placed between cabinetry. Adjust the feet so that the dishwasher sits securely under the benchtop.
z
If a problem occurs, consult the ‘Troubleshooting’ section of the User guide.
z
If after checking these points you still need assistance, please refer to the Service & Warranty book for warranty details and your nearest Authorised Service Centre, or contact us through our
website, listed below.
To Next Page
Loading...
Need help?
General
