ProcessMeter
Power-Up Options
27
Power-Up Options
To select a power-up option, hold down the pushbutton
shown in Table 11 while turning the rotary switch from
OFF to any on position. Wait 2 seconds before you
release the pushbutton after powering up the meter. The
meter beeps to acknowledge the power-up option.
Only the setting for current span is retained when the
power is turned off. The others have to be repeated for
each operating session.
You may activate more than one power-up option by
holding down more than one pushbutton.
Table 11. Power-Up Options
Option Pushbutton Default Action Taken
Change current span 0% setting K Remembers
last setting
Toggles between 0 and 4 mA
Disable beeper T Enabled Disables beeper
Disable auto power-off BLUE Enabled Disables the feature that turns off the meter
power after 30 minutes of inactivity. Auto
power off is disabled regardless of this
option if MIN MAX recording is on.
To Next Page
Loading...
Need help?
General
