TERRAIN MANAGEMENT (IF EQUIPPED)
This system optimizes drivability and comfort as well as maximizing
traction while operating on different types of terrain.
Turn the control located on the center console to choose between the
following modes:
1. Grass/Gravel/Snow mode should be selected where a firm surface is
covered with loose or slippery material such as packed snow, ice, water,
grass, or a thin layer of gravel or sand. For deep gravel or sand, select
Sand mode. If the vehicle cannot gain traction in deep snow, turning off
the traction control system may help (turn traction control back on when
traction is regained). See the Traction Control chapter.
2. Sand mode should be selected in soft dry sand or deep gravel. If
crossing wet sand that may be sufficiently deep enough for the wheels to
sink into the surface, select Mud/Ruts mode.
3. Mud/Ruts mode should be selected for muddy, rutted, soft, or uneven
terrain.
4. Normal mode is for on-road conditions and should be selected before
driving on surfaces which are similar to a hard road surface or once the
need for a special mode has passed. Select Normal mode when towing a
trailer.
Note: Cruise control is available only in Normal and Snow modes.
Note: The Sand and Mud/Ruts modes are for off-road use only.
Note: The curve control portion of the AdvanceTrac® system is
unavailable when Sand or Mud/Ruts is selected.
1
2
3
4
226 Terrain Response
2014 Explorer (exp)
Owners Guide gf, 1st Printing, April 2013
USA (fus)
To Next Page
Loading...
Need help?
General
