EasyManuals Logo
Home>Ford>Engine>LRG 425

Ford LRG 425 User Manual

Ford LRG 425
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
24
Check Engine Oil Level
1. Make sure the equipment is standing level and that the engine is stopped.
2. Pull out the dipstick and wipe it with a clean rag.
3. Insert the dipstick fully and again remove it. At no time should the level of the
oil fall below the lower mark on the dipstick.
4. If necessary, top up to the dipstick higher mark with an approved type and grade
of oil.
5. Replace the dipstick, ensuring that it is fully inserted into its tube to maintain a
sealed crankcase condition
Renew Engine Oil Filter
Your engine is equipped with a Motorcraft oil filter. A filter of this quality should be
used throughout the life of the engine. It is designed to protect your engine by
filtering harmful abrasive and sludgy particles without clogging up or blocking the
flow of the oil to vital engine parts. This filter is especially designed for use in
engines built by Ford to give successful operation with the recommended oil filter
change intervals. Contact your nearest Ford Power Product Distributor/Dealer
listed in the back section to obtain the correct filter. Before commencing, place a
drain pan beneath the filter to catch any spilt oil.
1. Using a suitable strap wrench, unscrew the oil filter canister.
2. Thoroughly clean oil filter housing face.
3. Partly pre-fill the new filter with clean engine oil of the correct type and grade.
Apply a thin film of clean engine oil to the oil filter sealing ring.
4. Screw on new oil filter canister until sealing ring abuts the filter head and tighten
a further 1/2 turn. Do NOT use a strap wrench or similar tool to tighten the filter
canister.
5. Run engine and check for any leaks from oil filter.
6. Stop engine, allow oil to settle and top up as necessary.
Gasoline Fuel System - EFI
In the event that your engine is equipped with an EFI (Electronic Fuel Injection)
system follow normal maintenance service. Any necessary service repairs should
be made by your Ford Power Products Distributor. The adjusting procedure
requires the use of tools which are not readily available to consumers. Please
contact Ford Power Products Distributors listed in the back section of this manual.

Table of Contents

Other manuals for Ford LRG 425

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ford LRG 425 and is the answer not in the manual?

Ford LRG 425 Specifications

General IconGeneral
BrandFord
ModelLRG 425
CategoryEngine
LanguageEnglish

Related product manuals