Black plate (119,1)
Windscreen Wipers and
Washer
The ignition switch must be in the ON
position.
NOTE
Because something heavy can jam the
wiper blades, the wiper motor is
protected from motor breakdown,
overheating and possible fire by a
circuit breaker. This mechanism will
automatically stop operation of the
blades, but only for about 5 minutes.
If this happens, turn off the wiper
switch and park off the right-of-way,
and remove the object.
After 5 minutes, turn on the switch and
the blades should operate normally. If
they do not resume functioning, consult
an expert repairer, we recommend an
Authorised Ford Repairer as soon as
possible. Drive to the side of the road
and park off the right-of-way. Wait until
the weather clear s before trying to drive
with the wipers inoperative.
qWindscreen Wipers
Turn the wipers on by pulling the lever
down.
INT ― Intermittent
1 ― Low speed
2 ― High speed
For a single wiping cycle, push the lever
up to
.
― Mist
Variable-speed intermittent wipers
Set the lever to INT and choose the
interval timing by rotating the ring.
INT ring
Driving Your Ford
Switches and Controls
5-41
RANGER_F8M1-10-08I_Edition1 Page119
Friday, September 26 2008 3:6 PM
Form No.F8M1-10-08I
To Next Page
Loading...
Need help?
General
