FS S3200 Series User Manual

1. Plug the AC power cord into the power port on the back panel of the switch.
2. Connect the other end of the power cord to an AC power source.
1. Connect one end of an Ethernet cable to the RJ45 port.
2. Connect the other end of the Ethernet cable to another network device.
Connecting the RJ45 Ports
Connecting the SFP/SFP+ Port
WARNING: Do not install power cord while the power is on.
EN
8
Left LED: Link/Act Mode Right LED: PoE Mode
SYS
PWR
PoE
CONSOLE
S3200-8M4GS-U
PoE+
1 2 3 4
5 6 7 8
10G
S3200-8M4GS-U
PoE+
Left LED: Link/Act Mode Right LED: PoE Mode
SYS
PWR
PoE
CONSOLE
1 2 3 4
5 6 7 8
9
10
11
12
10G

FS S3200 Series Specifications

General

Series	S3200 Series
Managed	Yes
MAC Address Table Size	16K
Type	Switch
Uplink Ports	2/4 x 10GE SFP+
Forwarding Rate	95.2 Mpps
Jumbo Frame Support	9K
Management	Web, CLI, SNMP
Power Supply	AC 100-240V
Weight	4.5 kg
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Dimensions (W x D x H)	440 x 200 x 44 mm (17.3 x 7.9 x 1.7 in)