18
Preparations
Changing Paper Size and Orientation
After loading paper into tray, make sure to set the size and orientation of the paper.
* You cannot change the setting while the machine is processing a job.
1 Press the <Paper Supply> button to select the
desired tray.
In the status machine diagram, the tray indicator lights up on the
selected tray, and its paper size and orientation are displayed on
the paper size display.
******************************************************************************************************
2 Press and hold the <Size (Press 2sec.)> button for
more than two seconds until the paper size in the
paper size display area blinks.
The paper size in the paper size display area blinks and the
machine enters paper size setting mode.
******************************************************************************************************
3
Press the <Size (Press 2sec.)> button to select the size and orientation of paper loaded in the
selected tray.
The selected paper size and orientation are displayed in the paper size display area.
The <Start> button lights up blinking during the settings.
******************************************************************************************************
<Size (Press 2sec.)> button
To Next Page
Loading...
Need help?
General
