1 Preparation to Print
20
1.4 Connecting AC Adapter (Charging)
The battery is charged by the printer's built-in charger.
1. Please connect the AC cable with the
AC adapter, and connect the AC plug to
an outlet.
2. Please open the jack cover.
Insert DC output terminal of AC
adapter into the AC adapter jack.
3. When the charge starts, the LED turns red, and when the battery
is fully charged, the LED turns off. Please refer to chapter 3.3 for
the LED display of charging status.
4. Please hang the hook of the jack cover
to the hole of AC jack, and push center
of the jack cover to close.
Caution
Please stop charging immediately if an abnormal charge is generated.
To Next Page
Loading...
Need help?
General
