Getting started
Removing monitor base
Before you can use a swivel arm or a similar accessory, you must remove the monitor base.
The display surface is susceptible to scratching!
1
1
1
1
► Switch off the monitor and pull the power
plug out of the power socket.
► Lay the monitor on its face on a soft surface.
► Disconnect all cables.
► To release the stand, remove the four
screws (1) that hold the stand in the VESA
mount. Then lift the stand away upwards.
You can now mount a swivel arm or a
similar accessory in accordance with VESA
FPMPMI using a hole spacing of 100 mm.
For instructions on how to mount the swivel arm or a similar accessory, please
see the documentation for the swivel arm or similar accessory.
Fujitsu 15
To Next Page
Loading...
Need help?
General