Operation
Function Description
Auto Brightness
Enable/disable automatic control of the brightness
This function is used to automatically control the brightness of the
background lighting using the ambient light sensor.
This setting only appears on models with an ambient light sensor and can
only be enabled in Office, Photo or Custom mode.
As soon as Auto brightness is enabled, ACR is automatically disabled
Lighting Guide
Enable/disable advice on
workplace lighting
With this function, advi
ce is displayed if the ambient light at the workplace
does not meet the ergonom
ic recommendations for working at the computer
screen.
This setting only appea
rs on models with a light sensor.
Auto level
Adjust the signal leve
l
With this function y
ou can automatically set the contrast.
Press the
button to run the function.
This setting only appears with an analogue video signal (e.g. VGA).
Locking the OSD menu
The OSD menu can be locked to prevent accidental or unauthorised changes to the monitor settings.
► Press the
button and the ON/OFF button at the same time and
keep them pressed for several seconds.
The message OSD locked / unlocked is displayed.
Please proceed in the same manner to release the locked OSD menu again.
Lock the ON/OFF button
The ON/OFF button can be locked to prevent accidental or unauthorised
changes to the monitor settings.
► Press the buttons
and at the same time and keep them pressed for a few seconds.
The message Power button locked / unlocked is displayed.
To remove the locking of the ON/OFF button again, proceed in the same way.
Fujitsu 35
To Next Page
Loading...
Need help?
General