Fujitsu PRIMERGY TX1330 M2 User Manual

TX1330 M2 Operating Manual 47
Hardware installation
5.2 Setting up the floorstand model
I If you are not installing a PRIMERGY TX1330 M2 floorstand model, skip
this section and continue reading at section "Installing/removing the rack
model" on page 48.
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see section "Unpacking the server").
Ê Set up the server.
V CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê Wire the server. Follow the instructions in sections "Connecting devices to
the server" on page 50 and "Notes on connecting/disconnecting cables" on
page 54.
Ê Connect the server to the mains (see section "Connecting the server to the
mains" on page 51).

Fujitsu PRIMERGY TX1330 M2 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX1330 M2
Category	Server
Language	English