Fujitsu ScanSnap fi-5110EOX Getting Started

18 |
6. Remove the Pick roller from the shaft.
Pull out the shaft from the Pick roller while lifting up
its tab.
A
TTENTION
If you push up the pick roller tab using your
fingernail, it may heart or get chipped your
fingernail. If you worry about that, you push up
the pick roller tab using a paper clip.
1
2
7. Attach the new Pick roller to the shaft.
Insert the new Pick roller aligning the protrusion with
the slot on the Pick roller.
8. Install the Pick roller with its shaft into the scanner.
and set the shaft to the slot while lowering it.
9. Fix the Pick roller bushing (left) by rotating it in the
direction of the arrow.
A
TTENTION
Make sure that the Pick roller is
completely attached and correctly
installed. Otherwise, document jams or
other feeding errors may occur.
10. Attach the sheet guide to the scanner.
While holding the handle on the sheet guide, set the sheet
guide into the scanner.
ÖYou should hear the sheet guide click when it
returns to its original position.
11. Close the ADF.
ÖYou should hear the ADF cover click when it
returns to its original position.
12. Turn on the scanner.
Ö ScanSnap Manager icon changes from to .
Shaft
Pick roller
Groove
Protrusion
Shaft
Pick roller
Tab
S
Sheet guide
Craw
Handle
ADF cover
Shaft
Pick roller bushing
Pick roller
Shaft
Pick roller
Bushing

Fujitsu ScanSnap fi-5110EOX Specifications

General

Brand	Fujitsu
Model	ScanSnap fi-5110EOX
Category	Scanner
Language	English