ScanSnap fi-5110EOX Getting Started | 7
HINT
This window is not displayed automatically
when the "Autoplay" setting of your computer is
disabled. In this case, run “Setup.exe” of this
CD-ROM directly using the “Explore” or “My
computer”.
2. Click the [Install Products] button.
Ö The installation of ScanSnap Manager, CardMinder and
PDF Thumbnail View starts up, and the wizard window
appears.
3. The setup window appears. Follow the instructions on
the window to install the application.
HINT
The following window appears during the
installation.
[Typical] <Recommended
>
“ScanSnap Manager”, “CardMinder” and “PDF
Thumbnail View” are installed including their
manuals.
[Compact]
“ScanSnap Manager” is installed including its
manual.
[Custom]
You can select the software and the manuals
to install.
4. After the installation is completed, please restart your
computer.
TTENTION
Refer to the “ScanScnap Operator’s Guide”
to learn more about ScanSnap Manager or
the installation of CardMinder.
2.2. Connecting the Scanner
After the computer has been restarted, please connect the
scanner.
2.2.1. Connecting the AC cable
TTENTION
Do not use cables other than the ones supplied
with this product. Use only the specified AC cables
and AC adapter.
1. Connect the AC cable to the AC adapter.
2. Insert the connectors of the AC adapter to the scanner
inlet and a power outlet.
2.2.2. Connecting the USB cable
Follow the procedure below to connect the USB cable.
TTENTION
● Use the USB cable supplied with this scanner.
The operation with a commercially available
USB cable is not guaranteed.
● When connecting to a USB hub, be sure to
connect the scanner to the hub nearest to your
computer (first stage). If you connect it to a USB
hub from the second stage onwards, ScanSnap
may not operate correctly.
1. Remove the seal from the USB connector.
2. Connect the scanner and your computer with the USB
cable.
USB cable
Outlet
Inlet
To Next Page
Loading...
Need help?
General