Fujitsu ScanSnap S300M User Manual

15
Chapter 2 Connecting the ScanSnap
This chapter describes how to connect the ScanSnap to your computer.
2.1 Installing the Supplied Software
Before connecting the ScanSnap to your computer, install the following software on your
computer.
(3: Supported, –: Not supported)
*1) When the operating system you are using is Mac OS X v10.2.8.
*2) When the operating system you are using is Mac OS X v10.3.9.
■ Installing Cardiris
1. Insert the "Cardiris™ Setup CD-ROM" into the CD-ROM drive.
2. Double-click the "Cardiris 3.6 for ScanSnap" on the desktop.
3. Double-click the "Cardiris 3.6 for ScanSnap" icon.
⇒A screen of Cardiris installation appears.
Software Mac OS X
v10.1
Mac OS X
v10.2 (*1)
Mac OS X
v10.3
Mac OS X
v10.4
Mac OS X
v10.5
ScanSnap Manager
(Driver)
– 3333
Cardiris
––3(*2) 33
ATTENTION
• We recommend applying the latest updates to the Mac OS for better
reliability.
• Log on as a user with Administrator privileges.
• Requirements for the ScanSnap S300M are as follows:
CPU
: - PowerPC
®
G4 Processor 800MHz or higher
- Intel
®
Core™ Solo or Duo Processor
(Intel
®
Core™ Duo Processor 1.83GHz or higher is
recommended)
Memory
: 128MB or more
(512MB or more is recommended. When the OS is
Mac OS X v10.5, 1GB or more is recommended.)
* If the CPU and memory do not meet the recommended requirements
or the USB version 1.1 is used, the scanning speed will slow down.
Prepare the Cardiris CD-ROM.

Fujitsu ScanSnap S300M Specifications

General

Brand	Fujitsu
Model	ScanSnap S300M
Category	Scanner
Language	English