ScanSnap S300M Getting Started 34
5.3 Cleaning Inside of the ScanSnap
Clean inside of the ScanSnap with a cloth moistened with Cleaner F1.
In an alternating succession of scanning documents, the accumulated paper-powder and
dust inside the ScanSnap causes a scanning error.
As a guideline, clean the ADF every 200 sheets of documents. Note that this guideline
varies according to the type of documents you are scanning. For example, the ADF must
be cleaned more frequently when scanning documents on that the toner has not been
sufficiently fixed on.
Clean the ADF according to the following procedure referring to the illustrations.
1. Open the ADF while pulling the Cover open lever.
2. Clean the following locations with a cloth moistened with Cleaner F1.
ATTENTION
• Never use water or neutral detergent to clean the inside of the ScanSnap.
• Do not use aerosol sprays to clean the ScanSnap. Aerosol sprays cause
dirt and dust to enter the ScanSnap, resulting in the ScanSnap failure,
malfunction and image error.
For more details, refer to "Chapter 8 Daily Care" in the "ScanSnap
S300M Operator’s Guide."
ADF
Cover open lever
Plastic rollers (x4)
Pick roller
Feed rollers (x2)
Glass (x2)
(Located on the ADF cover and the base unit.)
Eject rollers (x2)
Pad ASSY
White sheets (x2)
To Next Page
Loading...
Need help?
General