8 - English Important notes
• If the device is used with the swivel arm o r wall bracket, then avoid turning
the device by more than 180° or 270°.
• Store this manual close to the device. If you pass the device on to third
parties, you should pass this manual on with it.
• We recommend that you place your device on a durable, non-slip surface. In view
of the many different finishes and varnishes used on furniture, it is possible that the
feet of the device may mark the surface they stand o n.
Power cable
Use the supplied power cable only.
Use the following guidelines if it is necessary to replace the original cable set.
• The female/male receptacles of the cord set must meet IEC60320/CEE-22 requirements.
• The cable has to be HAR-certified or VDE-certified. The mark HAR or
VDE will appear on the outer sheath.
• For devices which are mounted on a desk or table, type SVT or SJT cab le sets may be
used. For devices which sit on the floor, only SJT type cable sets may be used.
• The cable s et must be selected according to the rated current for your device.
• If necessary, replace the original power cable with a regular grounded 3-core mains lead.
Transporting the device
Device,Trans porta tionRetransportation
Transport all parts separately in their original packaging or in a packaging which
protects them f rom knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be u sed,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same te mperature as the installation site.
Cleaning the device
Switch of
f the device and unplug the power plug.
Do not cle
an any interior pa rts yourself, leave this job to a service technician.
Do not us
e a ny cleaning agents that contain abrasives or may corrode plastic.
Ensure
that no liquid enters the device.
The display surface of the device i s sensitive to pressure and scratches. Clean
it only using a soft, slightly moistened cloth.
The surface of the casing can be cleane d w ith a dry cloth. If particularly dirty, use a cloth that
has been moistened in mild domestic d etergent and then carefully wrung out.
10 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General