-1
. SETTIN P
AIOS
DISPLAYS
.1 Selecting Data to Display
on the Data Display
The user may select what data to display in
four locations on the data display.
AN 12, 200 23: " U
12 23.4 N
123 23.4 E
POSITION
RN
31.23
nm
SO
12.3
kt
BR
223.4
CO
123.4
TO : 001
MARINE
POINT1
NE T : 002
MARINE
POINT2
User-defined
display data 1
User-defined
display data 2
User-defined
display data 4
User-defined
display data 3
User-defined
display window
W4
D3D 100m
SAFE
Figure 6-1 Data display
The data the user may select to display are
x Altitude (A T)*
x Average course (A R CO )
x Average speed (A R SO )
x Course (CO )
x Course error (dCO )
x Cross track error ( TE)
x Depth (W.DPT)
x Drift (DFT)
x ETA to waypoint (ETA)
x Heading (HD )
x Range to waypoint (RN )
x Bearing to waypoint (BR )
x Route time-to-go (RT.TT )
x Set (SET)
x Speed over ground (SO )
x Speed thru water (STW)
x Time-to-go to waypoint (TT )
x ETA to route
x Total route distance (RT.DIST)*
x Trip distance (TRIP)
x Trip elapsed time (TRIP TM)
x Water temperature (W.TMP) , and
x elocity to destination ( TD)*
ALT: Displayed only in 3D position fixing.
* T. DIST: Total distance from current
position to ultimate destination. Appears
when following a registered route or a
cursor-created route.
TD: When following a route, plus or minus
appears next to indication to denote which
direction the route is being traversed.
Requires external sensor.
1) Press MEN ESC, and 1 to display the
P OTTER SETUP menu.
P OTTER SETUP
Bearing Ref.
Auto
(07 W)
Man
(00 E)
ENT:Enter
MENU:Escape
Memory Apportion
Mag ariation
True
Trk 1000 2000Pt
Mag
R.
.C
Calculation
User defined 1 SO
User defined 2 CO
User defined 3 RN
User defined 4 BR
Figure 6-2 PLOTTER SETUP menu
2) Press
or to select one of four of
"User defined" ( 1, 2, 3, 4).
3) Press
or to select data to display.
4) Press the NC ENT key. To select the
data to display at other user defined
displays, repeat steps 2 and 3.
) Press the MEN ESC key.
To Next Page
Loading...
Need help?
General
