Original User Manual FUXTEC chainsaw FX-KS142_KS146_rev08
18
8. Cold start of the chainsaw
1. Pull out the choke (1) knob as far as it will go
2. Press the primer pump (2) 2-3 times
3. Block the chain brake (3) by pushing it forwards until you hear it
engage
4. Set the STOP switch (4) to position "1".
5. Place the saw on the floor and secure it with your right foot on the
floor
6. To do this, place your foot in the gas handle recess
7. Secure the saw with your left hand by holding the handle tube
8. Now start the saw by slowly pulling the pull starter (5) continuously.
ATTENTION: This is an Easy Starter. Therefore, DO NOT pull quickly
and jerkily. After the engine has ignited for the first time, you must
press the throttle lever to engage the automatic choke. Then pull the
cable starter until the engine starts
9. If the saw does not start, repeat this (point 8) several times
10. Release the chain brake immediately afterwards. Do not
accelerate when the chain brake is blocked, otherwise the clutch will
be damaged
Switch off the engine:
1. Set the STOP switch (4) to position "0
NOTE: Always drain the appliance before turning it off
To Next Page
Loading...
Need help?
General
