Original User Manual FUXTEC chainsaw FX-KS142_KS146_rev08
19
9. Warm start of the chainsaw
1. The choke button (1) is not pulled when warm
2. Block the chain brake (3) by pushing it forwards until you hear it
engage
3. Set the STOP switch (4) to position "1".
4. Place the saw on the floor and secure it with your right foot on the
floor
5. To do this, place your foot in the gas handle recess
6. Secure the saw with your left hand by holding the handle tube
7. Now start the saw by slowly pulling the pull starter (5) continuously.
ATTENTION: This is an Easy Starter. Therefore, DO NOT pull quickly
and jerkily.
8. If the saw does not start, repeat this several times
9. Release the chain brake immediately afterwards. Do not accelerate
when the chain brake is blocked, otherwise the clutch will be
damaged
To Next Page
Loading...
Need help?
General
