FUXTEC FX-MS125 User Manual

Original Bedienungsanleitung FUXTEC FX-MS125_de_en_fr_ita_es_rev01
65
2. Difficulties during operation
Situation
Cause
Solution
The engine does
not reach the
speed
Choke is in "COLD START" position, the
exhaust system is blocked no air supply,
moving elements worn, ignition spark
weak too large valve clearance, cylinder
head sooty
Open choke, replace exhaust system
Check or replace ignition coil, adjust
flywheel, spark plug
Operating
materials are
leaking
Lines to carburetor blocked Spark plug
spacing incorrect
Replace lines and carburetor Adjust
gap dimension
Motor-
Noises
Wrong choke position,
Camshaft damaged
Check/replace camshaft
Carburetor
leaking
Failure of the check valve on the tank cap
Replace the fuel filler cap
Carburetor gasket is worn out
Replace carburetor or gasket
If no troubleshooting solves the problem, please contact the FUXTEC
customer service. Only use original parts approved by the
manufacturer. Otherwise, there is a risk of danger.
 Customer Service
Have your purchased device repaired only by qualified personnel and only with original spare parts.
This will ensure that the safety of the device is maintained.
Please contact the manufacturer FUXTEC GmbH directly at www.fuxtec.co.uk at any time
regarding maintenance work and the procurement of spare parts.

FUXTEC FX-MS125 Specifications

General

Brand	FUXTEC
Model	FX-MS125
Category	Trimmer
Language	English