Garmin PANOPTIX LIVESCOPE LVS32 User Manual

Assembling the Trolling Motor Shaft Mount Hardware
With the trolling motor bracket oriented correctly (Trolling Motor Shaft Bracket Orientation, page 5), use the
included hex wrench to attach the transducer to the trolling shaft bracket with the shoulder screw ,
flat washer , and rubber washer .
NOTE: You must fully tighten the mount to the transducer. The recommended torque applied to the shoulder
screw is 2.5 lb-ft. (3.4 N-m).
Installing the Transducer on the Trolling Motor Shaft
NOTICE
You must secure the transducer cable to the shaft or other secure location during installation. Damage to the
transducer cable wire or the cable jacket can cause transducer failure.
You should mount the transducer as far from the motor as possible.
You should use the included rubber insert on a 25 mm (1 in.) trolling motor shaft.
1 Using the included hex wrench, insert the M6 screws and attach the shaft trolling bracket to the
transducer bracket around the trolling motor shaft.
2 Secure the transducer cable to the motor shaft or other secure location.
3 Route the transducer cable to the installation location of the sonar module while taking these precautions.
• You should not route the cable close to electrical wires or other sources of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is deployed or stowed.
4 Position the transducer to your desired angle (Trolling Motor Shaft Orientation, page 7).
6

Garmin PANOPTIX LIVESCOPE LVS32 Specifications

General

Brand	Garmin
Model	PANOPTIX LIVESCOPE LVS32
Category	Fishing Equipment
Language	English