8
The page feature helps you locate a misplaced handset. To send and receive
pages, all handsets must be registered. If your handset is not registered, follow the
instructions in the Registration section of this manual.
1. Make sure the phone is (not in TALK mode).
. Press and release the delete/intercom/conf button on a handset.
PAGING
EXTENSION? shows in the display.
. Use the touch-tone pad to enter the handset number you want to page.
. To cancel the page, press the END/cancel, delete/intercom/conf, or TALK button
on the originating handset, or press the END/cancel button on the receiving
handset.
1. Make sure the originating phone is (not in TALK mode).
. Press and release the delete/intercom/conf button on a handset.
PAGING
EXTENSION? shows in the display.
. Use the touch-tone pad to enter the handset number you want to page. (1= to
page Handset 1, =to page handset , etc., and * tone=to page all handsets)
. To cancel the page, press the END/cancel, delete/intercom/conf, or TALK button
on the originating handset, or press the END/cancel button on the receiving
handset.
Use the base-only to page all registered handsets at the same time.
1. Press the nd button on the base. All handsets beep for two minutes, and
PAGING
FROM BASE shows on each handset’s display.
. To cancel the page, press the nd button on the base, or press the TALK button or
the END/cancel button on each handset.
To Next Page
Loading...
Need help?
General
