GE Concord express User Manual

Appendix A: User Sheets
20
Arming Information
Delay Doors and Delay Time Settings
When the system is armed, enter and exit the premises
only through designated delay doors.
The time allowed to enter the premises and disarm the sys-
tem is the Entry Delay time.
The time allowed to leave the premises after arming the
system is the Exit Delay time.
Paging
For what events will the central station or pagers be noti-
fied?
Is the Streamlining feature enabled?
q Yes. When the system pages me, the message
will not include the central station account num-
ber.
q No. All pages from my system will include the
account number.
q According to my pager provider, the central sta-
tion account number will appear as:
_______________________________________
If the Power Goes Out
Your system has a backup battery that keeps your system
operational during a power failure. An optional feature
allows your system to alert the central monitoring station
if the power is off for more than 15 minutes. It reports
again when power has been restored.
No Activity Time
My system uses the No Activity feature.
q Yes. If there is no activity in my system for ____
hours (1-42, default 24), the system will send a
No Activity report to the Central Station.
q No. My system setup does not include this fea-
ture.
System Information
Door Door Location Entry
Dela
y
Exit
Dela
y
1 : :
2 : :
3
: :
4
: :
5
: :
Feature My system features include:
Quick Arm q Yes. Press the arming level desired.
q No. Enter arming level, then access code.
Quick Exit
q Yes. Press D and exit your armed pre-
mises through a delay door within 2 min-
utes.
q No. I need to disarm my system in order to
exit the premises.
Exit
Extension
q Yes. If I reenter the armed premises during
the Exit Delay time, the Exit Extension
will begin.
q No. If I reenter the armed premises during
the Exit Delay time, it will continue to
count down and I must disarm the system.
Keyswitch
Arming
q Yes. I can use a key to arm the system. The
switch is located:
_______________________________
_______________________________
q No.
Auto STAY
Arming
q Yes. If, after arming to Level 3—AWAY, I
don’t exit through a designated delay door,
the system will arm to Level 2—STAY.
q No. If, after arming to Level 3—AWAY, I
don’t exit through a designated delay door,
the system will continue to arm to Level
3—AWAY. And, if my system contains
motion detectors, movement may cause an
alarm.
Reporting Features CS 1 CS 2
Pagers
1 2 3
High Level Reports
Low Level Reports
Opening/Closing Reports
Latchkey Reports N/A N/A
System Information Code
Factory code
System number
System level

GE Concord express Specifications

General

Brand	GE
Model	Concord express
Category	Security System
Language	English