GE CYE23TSDFSS User Manual

Installation Instructions
INSTALLING THE REFRIGERATOR
REFRIGERATORLOCATION
• Do not install the refrigerator where the temperature will
go below 60°F(16°C)because it will not run often enough
to maintain proper temperatures,
• Do not install the refrigerator where the temperature will
go above l O0°F(37°0)because it will not perform properly,
• Install iton a floor strong enough to support it fully loaded,
CLEARANCES
Allowthe following clearances for easeof installation, proper
air circulation and plumbing and electrical connections,
Sides 1/8" (3 mm)
Top 1" (25mm) Cabinet/Hinge Cover
Back 2" (50mm)
REMOVINGTHEREFRIGERATORDOORS
• IMPORTANTNOTE.'Thisrefrigerator is 361/4"deep (311/4"
for CYEmodels),Doorsand passageways leading to the
installation location must be at least 36W' wide in order to
leavethe doors and handlesattached to the refrigerator
while transporting it into the installation location, If
passagewaysare lessthan 36W', the refrigerator doors and
handlescan easily be scratched and damaged, Thetop cap
and doors can be removed to allow the refrigerator to be
safelymoved indoors,If passageways are lessthan 31W',
start with Step 1,
• If it isnot necessaryto remove doors,skipto Step11,Leave
tape and all packaging on doors until the refrigerator is inthe
final location,
• NOTE."Usea padded hand truck to move this refrigerator,
Placethe refrigerator on the hand truck with a side against
the truck, Westrongly recommend that TWOPEOPLEmove
and complete this installation,
E]
E]
REMOVE THE FRESH FOOD
DOOR HANDLE
Handle Design varies based on models, however
Installation is same,
Stainlesssteel and plastic handles:
Q Loosen the set screws with the 1/8" Allen wrench and
remove the handle,
NOTE: If the handle mounting fasteners need to be tightened or
removed, use a 1/4" Allen wrench,
Mounting
Fasteners
Leave film
on until after
installation
REMOVE THE FREEZER DOOR HANDLE
Handle Designvaries based on models, however
Installation issame,
Stainlesssteel and plastic handles:
Loosen the set screws with the 1/8" Allen wrench and remove the
handle,
NOTE:Ifthe handle mounting fasteners need to be tightened or
removed, use a 1/4" Allen wrench,
Mounting
Fasteners
Leave film
on until after
installation
Reinstall the handles using the same
procedure as removing,
23

GE CYE23TSDFSS Specifications

General

Brand	GE
Model	CYE23TSDFSS
Category	Refrigerator
Language	English