EasyManuals Logo
Home>GE>Protection Device>F35

GE F35 User Manual

GE F35
682 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #542 background imageLoading...
Page #542 background image
6-10 F35 MULTIPLE FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
STATUS CHAPTER 6: ACTUAL VALUES
6
These actual values represent the state of direct devices 1 through 16.
6.3.18 EGD protocol status
6.3.18.1 Fast exchange
ACTUAL VALUES STATUS  EGD PROTOCOL STATUS PRODUCER STATUS FAST EXCHANGE 1
These values provide information for debugging an Ethernet Global Data (EGD) network. The EGD signature and packet size
for the fast EGD exchange display.
6.3.18.2 Slow exchange
ACTUAL VALUES STATUS  EGD PROTOCOL STATUS PRODUCER STATUS SLOW EXCHANGE 1(2)
These values provide information for debugging an EGD network. The EGD signature and packet size for the slow EGD
exchanges display.
6.3.19 Teleprotection channel tests
ACTUAL VALUES STATUS  TELEPROT CH TESTS
The status information for two channels is shown here.
CHANNEL 1 STATUS — This represents the receiver status of each channel. If the value is “OK,” teleprotection is enabled and
data is being received from the remote terminal; If the value is “FAIL,” teleprotection enabled and data is not being received
from the remote terminal. If “n/a,” teleprotection is disabled.
CHANNEL 1 LOST PACKETS — Data is transmitted to the remote terminals in data packets at a rate of two packets per cycle.
The number of lost packets represents data packets lost in transmission; this count can be reset to 0 through the
COMMANDS  CLEAR RECORDS menu.
VALIDITY OF CHANNEL CONFIGURATION — This value displays the current state of the communications channel identification
check, and hence validity. If a remote relay ID does not match the programmed ID at the local relay, the “FAIL” message
displays. The “N/A” value appears if the local relay ID is set to a default value of “0,” the channel is failed, or if the
teleprotection inputs/outputs are not enabled.
FAST EXCHANGE 1
FAST EXCHANGE 1
SIGNATURE: 0
FAST EXCHANGE 1
DATA LENGTH: 0
SLOW EXCHANGE 1
SLOW EXCHANGE 1
SIGNATURE: 0
SLOW EXCHANGE 1
DATA LENGTH: 0
TELEPROT CH TESTS
CHANNEL 1
STATUS: n/a
Range: n/a, FAIL, OK
CHANNEL 1 LOST
PACKETS: 1
Range: 1 to 65535 in steps of 1
CHANNEL 2
STATUS: n/a
Range: n/a, FAIL, OK
CHANNEL 2 LOST
PACKETS: 1
Range: 1 to 65535 in steps of 1
VALIDITY OF CHANNEL
CONFIGURATION: FAIL
Range: n/a, FAIL, OK

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE F35 and is the answer not in the manual?

GE F35 Specifications

General IconGeneral
BrandGE
ModelF35
CategoryProtection Device
LanguageEnglish

Related product manuals