111 /
Copyright General Electric 2011
9/23/2012
Cycle Information
Auto Hot Start: Not included in Cycle Chart
• Initiated when water in the Sump is lower than 80 Degrees F
• The Dishwasher will fill, circulate and sense, then drain up to 3 times,
attempting to raise incoming water temperatures
Wash Zone Option – GDT550 has an option of washing upper or lower
Racks. This will shorten the time by 30% (will not alternate spray arms).
Water use will not change. The cycle will “pulse” the selected wash zone arm,
using the algorithm discussed in the diverter operation portion of this
training presentation. If a consumer has a complaint of poor clean, make sure
this option is not selected.
Rinse Only Cycle is an 18 minute cycle with 3 Fill, Circulate and Drain
segments
To Next Page
Loading...
Need help?
General
