EasyManuals Logo
Home>GE>Water Filtration Systems>GXRV10ABL01

GE GXRV10ABL01 User Manual

GE GXRV10ABL01
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
Installation instructions.
Customer Service Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Customer Service Troubleshooting Tips
Installation Instructions
Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips
Installation Instructions
Safety Instructions
Operating Instructions
Things to Check Before Beginning Installation
FEED WATER—
The water supply to the
undercounter Reverse Osmosis system must
have the qualities listed in the specifications
(see the
Specifications Guidelines
section).
Municipal water supplies most often will
have these qualities.
Well water may need
conditioning—
have the water tested by a
water analysis laboratory and get their
recommendations for treatment.
CAUTION:
For water with a hardness
greater than 10 grains (at 6.9 pH),
the use of a softener is recommended.
Failure to install a softener will reduce
the life of the Reverse
Osmosis
membrane. See the
Specifications
Guidelines
section for additional
information on the possible need
for a softener.
DRAIN POINT*—
A suitable drain point and air
gap
(check your local codes)
are needed for
reject water from the Reverse Osmosis
membrane cartridge.
RO FAUCET—
The RO product water faucet
installs on the sink or on the countertop next
to the sink. Often, it is installed in an existing
sink spray attachment hole. Space is required
underneath for tubing to and from the faucet,
and for securing the faucet in place. All faucet
connections and installation procedures are
done on or above the sink or countertop.
Refer to Fig. 1 below.
BASEMENT INSTALLATION–
If installing in a
basement, leave enough tubing in place
during installation to be able to move unit to
floor for ease at servicing and making
filter/membrane changes.
FIG 1. INSTALLATION
OVERVIEW
Sump wrench
provided
RO product water faucet
mounted through sink
3⁄8
drain tubing
Water supply
valve or
compression
fitting
Hot Cold
Sink p-trap
Drain line*
6 1/4
15
16
9dia.
17
Depth
5 1⁄2
Reverse Osmosis system
Storage tank
*For drain line options see
Filtration Drain Connection Installations
section.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE GXRV10ABL01 and is the answer not in the manual?

GE GXRV10ABL01 Specifications

General IconGeneral
BrandGE
ModelGXRV10ABL01
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals